D-Link xStack DES-3200 Series - Page 251

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
24
6
show ipv6 neighbor_cache ipif
Used to displ
ay the IPv6 neighbor cache.
Purpose
sho
w ipv6 neighbor_cache ipif [<ipif_name 12> | all] [ipv6address
<ipv6addr> | static | dynamic | all]
Syntax
This
command is used to display the neighbor cache entry for the
specified interface. Display a specific entry, all entries, and all static
entries.
Description
Parameters
<ipif_name 12>  The interface’s name.
<ipv6addr>  The address of the entry.
static  The static neighbor cache entry.
dynamic  The dynamic entries.
Non
e.
Restrictions
Example usage:
To display the neighbors of the interface System:
DES-3200-28:4#show ipv6 neighbor_cache ipif System all
Command: show ipv6 neighbor_cache ipif System all
Neighbor Linklayer Address Interface State
---------------
Fe80::20b:6aff:fecf:7ec6 00:ob:6a:cf:7e:c6 System R
State :
(I) means Incomplete State. (R) means Reachable State.
(S) means Stale State. (D) means Delay State.
(P) means Probe State. (T) means Static State.
DES-3200-28:4#
create ipv6route
Used to creat
e an IPv6 static route.
Purpose
cre
ate ipv6route [default] [<ipif_name 12> <ipv6addr>] {<metric 1-
65535>}
Syntax
This
command is used to an IPv6 static route. If the next hop is a
global address, it is not needed to indicate the interface name. If the
next hop is a link local address, then the interface name must be
specified.
Description
default – Spe
cifies the default route.
Parameters
<ipif_name 12> – Specifies the interface for the route.
<ipv6addr>  Specifies the next hop address for this route.
<metric 1-65535>  Allows the entry of a routing protocol metric entry
representing the number of routers between the Switch and the IP
address above. The default setting is 1.
Only Administrator-level users
can issue this command.
Restrictions