D-Link xStack DES-3200 Series - Page 253

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
24
8
DES-3200-28:4#show ipv6 nd ipif System
Command: show ipv6 nd ipif System
Interface Name : System
NS Retransmit Time : 0(ms)
DES-3200-28:4#
show ipv6route
Used to displ
ay IPv6 routes.
Purpose
s
how ipv6route
Syntax
This
command is used to display IPv6 routes.
Description
Non
e.
Parameters
Non
e.
Restrictions
Example usage:
To display all the IPv6 routes:
DES-3200-28:4#show ipv6route
Command: show ipv6route
IPv6 Prefix: ::/0 Protocol: Static Metric: 1
Next Hop : 3FFC::1 IPIF : System
Total Entries: 1
DES-3200-28:4#
config ipv6 nd ns ipif
Used to co
nfigure neighbor solicitation related arguments.
Purpose
config ipv6 n
d ns ipif <ipif name 12> retrans_time <uint 0-4294967295>
Syntax
This
command is used to configure neighbor solicitation related
arguments.
Description
Parameters
<ipif_name>  The name of the interface.
retrans_timer  The neighbor solicitation’s retransmit timer in
milliseconds. This has the same value as ra retrans_time in the config
ipv6 nd ra command. If one is configured, the other will change, too.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the IPv6 nd ns interface: