D-Link xStack DES-3200 Series - Page 271

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
26
6
DES-3200-28:4#show authen_enable all
Command: show authen_enable all
Method List Name Priority Method Name Comment
---------------- -------- ------------- ------------------
Permit 1 tacacs+ Built-in Group
2 tacacs Built-in Group
3 ctsnow User-defined Group
4 local_enable Keyword
default 1 tacacs+ Built-in Group
2 local_enable Keyword
Total Entries : 2
DES-3200-28:4#
config authen application
Used to co
nfigure various applications on the Switch for
authentication using a previously configured method list.
Purpose
config a
uthen application [console | telnet | ssh | http | all] [login |
enable] [default | method_list_name <string 15>]
Syntax
This
command is used to configure Switch configuration applications
(console, telnet, ssh, web) for login at the user level and at the
administration level (authen_enable) utilizing a previously configured
method list.
Description
appli
cation – Choose the application to configure. The user may
choose one of the following five options to configure.
Parameters
console – Choose this parameter to configure the command line
interface login method.
telnet – Choose this parameter to configure the telnet login method.
ssh – Choose this parameter to configure the Secure Shell login
method.
http – Choose this parameter to configure the Web interface login
method.
all – Choose this parameter to configure all applications (console,
telnet, ssh, web) login method.
login – Use this parameter to configure an application for normal login
on the user level, using a previously configured method list.
enable  Use this parameter to configure an application for upgrading
a normal user level to administrator privileges, using a previously
configured method list.
default – Use this parameter to configure an application for user
authentication using the default method list.
method_list_name <string 15>  Use this parameter to configure an
application for user authentication using a previously configured
method list. Enter an alphanumeric string of up to 15 characters to
define a previously configured method list.