D-Link xStack DES-3200 Series - Page 28

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
23
To
save the Switch’s current log to non-volatile RAM:
DES-3200-28:4#save log
Command: save log
Saving all log information to NV-RAM...... Done.
Success.
DES-3200-28:4#
To save the Switch’s the current configuration and log to non-volatile RAM:
DES-3200-28:4#save all
Command: save all
Saving all configurations and log information to NV-RAM...... Done.
Success.
DES-3200-28:4#
reboot
Used to res
tart the Switch.
Purpose
rebo
ot {force_agree}
Syntax
This
command is used to restart the Switch.
Description
force
_agree – When force_agree is specified, the Switch will be
forced to restart immediately without further confirmation.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To restart the Switch:
DES-3200-28:4#reboot
Command: reboot
Are you sure you want to proceed with the system reboot?(Y|N)
Please wait, the switch is rebooting...
To force the Switch to restart:
DES-3200-28:4#reboot force_agree
Command: reboot force_agree
Please wait, the switch is rebooting...