D-Link xStack DES-3200 Series - Page 27

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
22
disable web
Used to disab
le the HTTP-based management software on the
Switch.
Purpose
disa
ble web
Syntax
This
command disables the Web-based management software on
the Switch.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To disable HTTP:
DES-3200-28:4#disable web
Command: disable web
Success.
DES-3200-28:4#
save
Used to save
changes in the Switch’s configuration to non-volatile
RAM.
Purpose
save {[config|
log|all]}
Syntax
This
command is used to enter the current switch configuration into
non-volatile RAM. The saved switch configuration will be loaded into
the Switch’s memory each time the Switch is restarted.
Description
config –
Used to save the current configuration to a file.
Parameters
log – Used to save the current log to a file. The log file cannot be
deleted.
all – Save changes to currently activated configurations and save
log. If no keywords are specified, save the changes to the
configuration. If there are no keywords specified, the changes will be
saved to the configuration.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To save the Switch’s current configuration to non-volatile RAM:
DES-3200-28:4#save config
Command: save config
Saving all configurations to NV-RAM...... Done.
Success.
DES-3200-28:4#