D-Link xStack DES-3200 Series - Page 26

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
21
telnet
Used to Teln
et another device on the network.
Purpose
telnet <ipa
ddr> {tcp_port <value 0-65535>}
Syntax
This
command is used to connect to another device’s management
through Telnet.
Description
Parameters
<ipaddr>  Enter the IP address of the device to connect through,
using Telnet.
tcp_port <value 0-65535>  Enter the TCP port number used to
connect through. The common TCP port number for telnet is 23.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To connect to a device through telnet with an IP address of 10.53.13.99:
DES-3200-28:4#telnet 10.53.13.99 tcp_port 23
Command: telnet 10.53.13.99 tcp_port 23
enable web
Used to ena
ble the HTTP-based management software on the
Switch.
Purpose
enabl
e web {<tcp_port_number 1-65535>}
Syntax
This
command is used to enable the Web-based management
software on the Switch. The user can specify the TCP port number
the Switch will use to listen for Telnet requests.
Description
Parameters
<tcp_port_number 1-65535>  The TCP port number. TCP ports are
numbered between 1 and 65535. The “well-known” port for the Web-
based management software is 80.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable HTTP and configure port number:
DES-3200-28:4#enable web 80
Command: enable web 80
Note: SSL will be disabled if web is enabled.
Success.
DES-3200-28:4#