D-Link xStack DES-3200 Series

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
20
enable telnet
Used to ena
ble communication with and management of the Switch
using the Telnet protocol.
Purpose
enabl
e telnet {<tcp_port_number 1-65535>}
Syntax
This
command is used to enable the Telnet protocol on the Switch.
The user can specify the TCP port number the Switch will use to
listen for Telnet requests.
Description
Parameters
<tcp_port_number 1-65535>  The TCP port number. TCP ports
are numbered between 1 and 65535. The “well-known” TCP port for
the Telnet protocol is 23.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable Telnet and configure port number:
DES-3200-28:4#enable telnet 23
Command: enable telnet 23
Success.
DES-3200-28:4#
disable telnet
Used to disab
le the Telnet protocol on the Switch.
Purpose
disa
ble telnet
Syntax
This
command is used to disable the Telnet protocol on the Switch.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To disable the Telnet protocol on the Switch:
DES-3200-28:4#disable telnet
Command: disable telnet
Success.
DES-3200-28:4#