D-Link xStack DES-3200 Series - Page 284

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
27
9
To enable SSH:
DES-3200-28:4#enable ssh
Command: enable ssh
Success.
DES-3200-28:4#
disable ssh
Used to disab
le SSH.
Purpose
disa
ble ssh
Syntax
This
command is used to disable SSH on the Switch.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Usage example:
To disable SSH:
DES-3200-28:4# disable ssh
Command: disable ssh
Success.
DES-3200-28:4#
config ssh authmode
Used to co
nfigure the SSH authentication mode setting.
Purpose
config
ssh authmode [password | publickey | hostbased] [enable |
disable]
Syntax
This
command is used to configure the SSH authentication mode for
users attempting to access the Switch.
Description
password – T
his parameter may be chosen if the administrator
wishes to use a locally configured password for authentication on the
Switch.
Parameters
publickey  This parameter may be chosen if the administrator
wishes to use a publickey configuration set on a SSH server, for
authentication.
hostbased  This parameter may be chosen if the administrator
wishes to use a host computer for authentication. This parameter is
intended for Linux users requiring SSH authentication techniques
and the host computer is running the Linux operating system with a
SSH program previously installed.
[enable | disable]  This allows users to enable or disable SSH
authentication on the Switch.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable the SSH authentication mode by password: