D-Link xStack DES-3200 Series

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
28
0
DES-3200-28:4#config ssh authmode password enable
Command: config ssh authmode password enable
Success.
DES-3200-28:4#
show ssh authmode
Used to displ
ay the SSH authentication mode setting.
Purpose
sho
w ssh authmode
Syntax
This
command is used to display the current SSH authentication set
on the Switch.
Description
Non
e.
Parameters
Non
e.
Restrictions
Example usage:
To view the current authentication mode set on the Switch:
DES-3200-28:4#show ssh authmode
Command: show ssh authmode
The SSH Authmode:
-------------------------------------------------
Password : Enabled
Publickey : Enabled
Hostbased : Enabled
DES-3200-28:4#
config ssh server
Used to co
nfigure the SSH server.
Purpose
config
ssh server {maxsession <int 1-8> | timeout <sec 120-600> |
authfail <int 2-20> | rekey [10min | 30min | 60min | never]} (1)
Syntax
This
command is used to configure the SSH server.
Description
Parameters
maxsession <int 1-8>  Allows the user to set the number of users
that may simultaneously access the Switch. The default setting is 8.
contimeout <sec 120-600>  Allows the user to set the connection
timeout. The user may set a time between 120 and 600 seconds.
The default is 120 seconds.
authfail <int 2-20>  Allows the administrator to set the maximum
number of attempts that a user may try to logon utilizing SSH
authentication. After the maximum number of attempts is exceeded,
the Switch will be disconnected and the user must reconnect to the