D-Link xStack DES-3200 Series - Page 301

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
29
6
show sim
Used to view
the current information regarding the SIM group on the Switch.
Purpose
sho
w sim {[candidates {<candidate_id 1-100>} | members {<member_id 1-32>} | group
{commander_mac <macaddr>} | neighbor]}
Syntax
This
command is used to display the current information regarding the SIM group on the
Switch, including the following:
Description
SIM Version  Displays the current Single IP Management version on the Switch.
Firmware Version  Displays the current Firmware version on the Switch.
Device Name  Displays the user-defined device name on the Switch.
MAC Address  Displays the MAC Address of the Switch.
Capabilities – Displays the type of switch, be it Layer 2 (L2) or Layer 3 (L3).
Platform – Switch Description including name and model number.
SIM State – Displays the current Single IP Management State of the Switch, whether it be
enabled or disabled.
Role State – Displays the current role the Switch is taking, including Commander, Member
or Candidate. A Stand-alone switch will always have the commander role.
Discovery Interval  Time in seconds the Switch will send discovery packets out over the
network.
Hold time – Displays the time in seconds the Switch will hold discovery results before
dropping it or utilizing it.
Parameters
candidates {<candidate_id 1-100>}  Entering this parameter will display information
concerning candidates of the SIM group. To view a specific candidate, include that
candidate’s ID number, listed from 1 to 100.
members {<member_id 1-32>}  Entering this parameter will display information
concerning members of the SIM group. To view a specific member, include that member’s
id number, listed from 1 to 32.
group {commander_mac <macaddr>}  Entering this parameter will display information
concerning the SIM group. To view a specific group, include the commander’s MAC
address of the group.
neighbor – Entering this parameter will display neighboring devices of the Switch. A SIM
neighbor is defined as a switch that is physically connected to the Switch but is not part of
the SIM group. This screen will produce the following results:
Port – Displays the physical port number of the commander switch where the uplink to the
neighbor switch is located.
MAC Address – Displays the MAC Address of the neighbor switch.
Role – Displays the role(CS, CaS, MS) of the neighbor switch.
Non
e.
Restrictions