D-Link xStack DES-3200 Series - Page 304

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
29
9
reconfig
Used to co
nnect to a member switch, through the commander switch,
using Telnet.
Purpose
reconfig [me
mber_id <value 1-32> | exit]
Syntax
This
command is used to reconnect to a member switch using Telnet
and to exit from managing the member switch and return to managing
the commander switch.
Description
Parameters
member_id <value 1-32>  Select the ID number of the member switch
to configure.
exit – This command is used to exit from managing the member switch
and will return to managing the commander switch.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To connect to the MS, with member ID 2, through the CS, using the command line interface:
DES-3200-28:4#reconfig member_id 2
Command: reconfig member_id 2
DES-3200-28:4#
config sim_group
Used to add
candidates and delete members from the SIM group.
Purpose
config sim_g
roup [add <candidate_id 1-100> {<password>} | delete
<member_id 1-32>]
Syntax
This
command is used to add candidates and delete members from
the SIM group by ID number.
Description
Parameters
add <candidate_id 1-100> <password>  Use this parameter to
change a candidate switch (CaS) to a member switch (MS) of a SIM
group. The CaS may be defined by its ID number and a password (if
necessary).
delete <member_id 1-32>  Use this parameter to delete a member
switch of a SIM group. The member switch should be defined by ID
number.
Only Administrator-level users
can issue this command.
Restrictions