xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
30
0
Example usage:
To add a member:
DES-3200-28:4#config sim_group add 1
Command: config sim_group add 1
Please wait for ACK !!!
SIM Config Success !!!
Success.
DES-3200-28:4#
To delete a member:
DES-3200-28:4# config sim_group delete 1
Command: config sim_group delete 1
Please wait for ACK !!!
SIM Config Success !!!
Success.
DES-3200-28:4#
config sim
Used to co
nfigure role parameters for the SIM protocol on the Switch.
Purpose
config
sim [[commander {group_name <groupname 64>} | candidate] |
dp_interval <sec 30-90> | hold_time <sec 100-255>]
Syntax
This
command is used to configure parameters of switches of the SIM.
Description
comm
ander – Use this parameter to configure a commander switch
(CS).
Parameters
candidate – Used to change the role to a CaS (candidate).
dp_interval <30-90> – The user may set the discovery protocol interval,
in seconds that the Switch will send out discovery packets. Returning
information to the CS will include information about other switches
connected to it. (Ex. MS, CaS). The user may set the dp_interval from
30 to 90 seconds.
hold time <100-255> – Using this parameter, the user may set the time,
in seconds, the Switch will hold information sent to it from other
switches, utilizing the discovery interval protocol. The user may set the
hold time from 100 to 255 seconds.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To change the time interval of the discovery protocol:
To Next Page
Loading...
Need help?
General
