xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
30
7
Example usage:
To disable SMTP on the Switch:
DES-3200-28:4#disable smtp
Command: disable smtp
Success.
DES-3200-28:4#
config smtp
Used to co
nfigure necessary information in setting up the Switch
as an SMTP client.
Purpose
config
smtp {server <ipaddr> | server_port <tcp_port_number 1-
65535> | self_mail_addr <mail_addr 64> | [add mail_receiver
<mail_addr 64> | delete mail_receiver <index 1-8>]} (1)
Syntax
This
command is used to set the necessary parameters to
configure the SMTP server and mail recipients. This command
must be completely configured properly for the SMTP function of
the switch to correctly operate.
Description
Parameters
server <ipaddr> Enter the IP address of the SMTP server on a
remote device.
server_port <tcp_port_number 1-65535> Enter the virtual port
number that the Switch will connect with on the SMTP server. The
common port number for SMTP is 25.
self_mail_addr <mail addr 64> Enter the e-mail address from
which mail messages will be sent. This address will be the from
address on the e-mail message sent to a recipient. Only one self
mail address can be configured for this Switch. This string can be
no more than 64 alphanumeric characters.
add mail_receiver <mail_addr 64> Choose this parameter to add
mail recipients to receive e-mail messages from the Switch. Up to
eight e-mail addresses can be added per Switch.
delete mail_receiver <index 1-8> Choose this parameter to
delete mail recipients from the configured list.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the SMTP settings:
DES-3200-28:4#config smtp server 166.99.66.33 server
To Next Page
Loading...
Need help?
General
