xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
31
6
DES-3200-28:4# config gratuitous_arp learning enable
Command: config gratuitous_arp learning enable
Success.
DES-3200-28:4#
config gratuitous_arp_send periodically
Used to co
nfigure the interval for periodical sending of gratuitous ARP
request packets.
Purpose
config g
ratuitous_arp_send periodically ipif <ipif_name 12> interval
<value 0-65535>
Syntax
This
command is used to configure the interval for periodical sending of
gratuitous ARP request packets. By default, the interval is 0.
Description
Parameters
<ipif_name 12> The IP interface name of the Switch.
<value 0-65535> Periodically send gratuitous ARP interval time in
seconds. 0- means it will not send gratuitous ARP periodically.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure gratuitous ARP intervals for the IPIF System:
DES-3200-28:4#config gratuitous_arp send periodically ipif System interval 5
Command: config gratuitous_arp send periodically ipif System interval 5
Success.
DES-3200-28:4#
enable gratuitous_arp
Used to ena
ble the gratuitous ARP trap and log.
Purpose
enabl
e gratuitous_arp {ipif <ipif_name 12>} {trap | log} (1)
Syntax
The co
mmand is used to enable gratuitous ARP trap and log states. The
Switch can trap and log the IP conflict event to inform the administrator.
By default, the trap is disabled and event log is enabled.
Description
Parameters
<ipif_name 12> IP interface name of the Switch.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable the System’s interface gratuitous ARP log and trap:
To Next Page
Loading...
Need help?
General
