D-Link xStack DES-3200 Series - Page 340

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
33
5
config mld_snooping querier
version <value 1-2> - Specifies the version of MLD packet that will be
sent by this port.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the MLD snooping querier query interval to 125 seconds and state enable:
DES-3200-28:4#config mld
_
snooping querier vlan default query
_
interval 125
state enable
Command: config mld
_
snooping querier vlan default query
_
interval 125 state
enable
Success.
DES-3200-28:4#
config mld_snooping mrouter_ports
Used to co
nfigure ports as router ports.
Purpose
config mld
_snooping mrouter_ports <vlan_name 32> [add | delete]
<portlist>
Syntax
This
command is used to designate a range of ports as being
connected to multicast-enabled routers. This will ensure that all
packets with such a router as its destination will reach the multicast-
enabled router  regardless of protocol, etc.
Description
<vlan_
name 32> - The name of the VLAN on which the router port
resides.
Parameters
[add | delete] - Specifies to add or delete the router ports.
<portlist> - Specifies a range of ports to be configured.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To set up a port range of 1 to 10 to be static router ports:
DES-3200-28:4# config mld_snooping mrouter_ports default add 1-10
Command: config mld_snooping mrouter_ports default add 1-10
Success.
DES-3200-28:4#
config mld_snooping mrouter_ports_forbidden
Used to co
nfigure ports as forbidden router ports.
Purpose
config mld
_snooping mrouter_ports_forbidden <vlan_name 32> [add
| delete] <portlist>
Syntax
This
command is used to designate a range of ports as being not
connected to multicast-enabled routers. This ensures that the
forbidden router port will not propagate routing packets out.
Description