xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
35
2
config max_mcast_group
config max_
mcast_group ports <portlist> max_group <value 1-
1024>
Syntax
This
command is used to configure the maximum number of
multicast groups that a port can join.
Description
<po
rtlist> - A range of ports to configure the maximum multicast
group.
Parameters
max_group - Specifies the maximum number of multicast groups.
The range is from 1 to 1024. 1024 is the default setting.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the maximum multicast address groups on ports 1 and 3 as 100:
DES-3200-28:4#config max_mcast_group ports 1,3 max_group 100
Command: config max_mcast_group ports 1,3 max_group 100
Success.
DES-3200-28:4#
show max_mcast_group
Used to displ
ay the maximum number of multicast groups that a port
can join.
Purpose
sho
w max_mcast_group ports {<portlist>}
Syntax
This
command is used to display the maximum number of multicast
groups that a port can join.
Description
<po
rtlist> - A range of ports to display the maximum number of
multicast groups.
Parameters
If no portlists are specified, the system will display the maximum
number of multicast groups for all ports.
Non
e.
Restrictions
Example usage:
To display the maximum number of multicast groups on port 1:
To Next Page
Loading...
Need help?
General
