D-Link xStack DES-3200 Series User Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
31
config greeting _message
Used to co
nfigure the login banner (greeting message).
Purpose
config g
reeting _message {default}
Syntax
Users ca
n use this command to modify the login banner (greeting message).
Description
default – If th
e user enters default to the modify banner command, then the banner will be
reset to the original factory banner.
Parameters
To open the Banner Editor, click Enter after typing the config greeting_message command.
Type the information to be displayed on the banner by using the commands described on
the Banner Editor:
Quit without save: Ctrl+C
Save and quit: Ctrl+W
Move cursor: Left/Right/Up/Down
Delete line: Ctrl+D
Erase all setting: Ctrl+X
Reload original setting: Ctrl+L
Only Administrator-level users
can issue this command. Other restrictions include:
Restrictions
If the “reset” command is executed, the modified banner will remain modified. However, the
“reset config/reset system” command will reset the modified banner to the original factory
banner.
The capacity of the banner is 6*80. 6 Lines and 80 characters per line.
Ctrl+W will only save the modified banner in the DRAM. Users need to type the “save
config/save all” command to save it into Flash.
Only valid in threshold level.
Example usage:
To modify the banner:
DES-3200-28:4# config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================================
DES-3200-28 Fast Ethernet Switch
Command Line Interface
Firmware: Build 1.20.B.010
Copyright(C) 2008 D-Link Corporation. All rights reserved.
================================================================================
<Function Key> <Control Key>
Ctrl+C Quit without save left/right/
Ctrl+W Save and quit up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
--------------------------------------------------------------------------------

D-Link xStack DES-3200 Series Specifications

General

Managed	Yes
Layer	Layer 2
MAC Address Table Size	8K
Quality of Service (QoS)	802.1p
Security Features	ACL, 802.1X, Port Security
Jumbo Frame Support	Up to 9KB
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Forwarding Rate	13.1 Mpps (48-port)