D-Link xStack DES-3200 Series - Page 363

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
35
8
config lldp tx_delay
Used to ch
ange the minimum time (delay-interval) of any LLDP port. It
will delay advertising successive LLDP advertisements due to a change
in LLDP MIB content. The Tx delay defines the minimum interval
between the sending of LLDP messages due to constant changes of MIB
content.
Purpose
config lld
p tx_delay <sec 1–8192>
Syntax
The LL
DP message_tx_interval (transmit interval) must be greater than
or equal to (4 x tx_delay interval).
Description
tx_delay - Th
e range is from 1 second to 8192 seconds. The default
setting 2 seconds.
Parameters
NOTE: The Tx Delay should be less than or equal to 0.25 *
msgTxInterval
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To configure the delay-interval interval:
DES-3200-28:4# config lldp tx_delay 8
Command: config lldp tx_delay 8
Success.
DES-3200-28:4#
config lldp reinit_delay
Cha
nge the minimum time of re-initialization delay interval.
Purpose
config lld
p reinit_delay <sec 1–10>
Syntax
An re-e
nabled LLDP port will wait for reinit_delay after last disable
command before reinitializing
Description
reinit_d
elay - The range is from 1 second to 10 seconds. The default
setting 2 seconds.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To change the re-initialization delay interval:
DES-3200-28:4# config lldp reinit_delay 5
Command: config lldp reinit_delay 5
Success.
DES-3200-28:4#