D-Link xStack DES-3200 Series

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
35
9
config lldp notification_interval
Used to co
nfigure the timer of the notification interval used to send
notifications to configured SNMP trap receiver(s).
Purpose
config lld
p notification_interval <sec 5 - 3600>
Syntax
Globally chan
ge the interval between successive LLDP change
notifications generated by the switch.
Description
notification
_interval - The range is from 5 second to 3600 seconds. The
default setting is 5 seconds.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To change the notification interval:
DES-3200-28:4# config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DES-3200-28:4#
config lldp ports notification
Used to co
nfigure each port for sending notifications to configured SNMP
trap receiver(s).
Purpose
config lld
p ports [<portlist>|all] notification [enable | disable]
Syntax
Enable o
r disable each port for sending change notifications to
configured SNMP trap receiver(s) if an LLDP data change is detected in
an advertisement received on the port from an LLDP neighbor. The
definition of change includes new available information, information
timeout and information update. The changed type includes any data
update /insert/remove.
Description
<po
rtlist> - Specify a range of ports to be configured.
Parameters
all - To set all ports in the system, use the “all” parameter.
notification - Enables or disables the SNMP trap notification of LLDP data
changes detected on advertisements received from neighbor devices.
The default notification state is disabled.
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To change the port SNMP notification state:
DES-3200-28:4# config lldp ports 1-5 notification enable
Command: config lldp ports 1-5 notification enable
Success.
DES-3200-28:4#