D-Link xStack DES-3200 Series - Page 394

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
38
9
enable address_binding trap_log
Used to ena
ble the trap log for the IP-MAC-port binding function.
Purpose
enabl
e address_binding trap_log
Syntax
This
command, along with the disable address_binding trap_log will
enable and disable the sending of trap log messages for IP-MAC-
port binding. When enabled, the Switch will send a trap log message
to the SNMP agent and the Switch log when an ARP packet is
received that doesn’t match the IP-MAC-port binding configuration
set on the Switch.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable the sending of IP-MAC-port binding trap log messages on the Switch:
DES-3200-28:4#enable address_binding trap_log
Command: enable address_binding trap_log
Success.
DES-3200-28:4#
disable address_binding trap_log
Used to disab
le the trap log for the IP-MAC-port binding function.
Purpose
disa
ble address_binding trap_log
Syntax
This
command, along with the enable address_binding trap_log will
enable and disable the sending of trap log messages for IP-MAC-
port binding. When enabled, the Switch will send a trap log message
to the SNMP agent and the Switch log when an ARP packet is
received that doesn’t match the IP-MAC-port binding configuration
set on the Switch.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To disable the sending of IP-MAC-port binding trap log messages on the Switch:
DES-3200-28:4#disable address_binding trap_log
Command: disable address_binding trap_log
Success.
DES-3200-28: