D-Link xStack DES-3200 Series - Page 40

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
35
DES-3200-28:4#config ports 25-28 speed 10_full state enable
Command: config ports 25-28 speed 10_full state enable
Warning: For combo ports, the configuration is set to medium_type copper
Success.
DES-3200-28:4#
show ports
Used to displ
ay the current configuration of a range of ports.
Purpose
sho
w ports {<portlist>} {[description | err_disabled]}
Syntax
This
command is used to display the current configurations of a range of ports. No
parameters will show all ports.
Description
Parameters
<portlist>  Specifies a port or range of ports to be displayed.
description – Adding this parameter to the show ports command indicates that a
previously entered port description will be included in the display.
err_disabled – Use this to list disabled ports including connection status and
reason for being disabled.
Non
e.
Restrictions
Example usage:
To display the configuration of all ports on a standalone switch:
DES-3200-28:4#show ports
Command show ports
Port State/ Settings Connection Address
MDI Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
----- -------- --------------------- --------------------- --------
1 Enabled 100M/Full/Disabled LinkDown Enabled
2 Enabled 100M/Full/Disabled LinkDown Enabled
3 Enabled 100M/Full/Disabled LinkDown Enabled
4 Enabled 100M/Full/Disabled LinkDown Enabled
5 Enabled 100M/Full/Disabled LinkDown Enabled
6 Enabled 100M/Full/Disabled LinkDown Enabled
7 Enabled 100M/Full/Disabled LinkDown Enabled
8 Enabled 100M/Full/Disabled LinkDown Enabled
9 Enabled 100M/Full/Disabled LinkDown Enabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh