D-Link xStack DES-3200 Series - Page 423

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
41
8
config mac_based_access_control auth_failover
Used to co
nfigure MAC-based access control authentication failover.
Purpose
config ma
c_based_access_control auth_failover [enable | disable]
Syntax
Whe
n the authentication failover is disabled, if RADIUS servers are
unreachable, the authentication will fail. When the authentication
failover is enabled, if RADIUS server authentication is unreachable, the
local database will be used to do the authentication. By default, the
state is disabled.
Description
enabl
e – Enable the protocol authentication failover.
Parameters
disable – Disable the protocol authentication failover.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable MAC-based access control authentication failover:
DES-3200-28:4#config mac_based_access_control auth_failover enable
Command: config mac_based_access_control auth_failover enable
Success.
DES-3200-28:4#
config mac_based_access_control guest_vlan ports
Used to co
nfigure MAC-based access control guest VLAN ports.
Purpose
config ma
c_based_access_control guest_vlan ports <portlist>
Syntax
This
command is used configure MAC-based access control guest
VLAN ports.
Description
portlist – Th
e list of ports to be configured.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To configure MAC-based access control guest VLAN ports:
DES-3200-28:4#config mac_based_access_control guest_vlan ports 1-2
Command: config mac_based_access_control guest_vlan ports 1-2
Success.
DES-3200-28:4#