D-Link xStack DES-3200 Series - Page 430

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
42
5
To display MAC-based access control local databases by VLAN:
DES-3200-28:4#show mac_based_access_control_local vlan default
Command: show mac_based_access_control_local vlan default
MAC Address VLAN Name VID
----------------- ---------------------- ------
00-00-00-00-00-01 default 1
00-00-00-00-00-04 default 1
Total Entries: 2
DES-3200-28:4#
show mac_based_access_control auth_state
Used to displ
ay the MAC-based access control authentication state.
Purpose
sho
w mac_based_access_control auth_state {ports <portlist>}
Syntax
This
command is used to display the MAC-based access control authentication state.
Description
ports –
Display authentication status by port.
Parameters
Non
e.
Restrictions
Example usage:
MAC 00-00-00-00-00-01 is authenticated without a VLAN assigned (the specified target VLAN might not exist or a target VLAN
has not been specified). The ID of RX VLAN will be displayed (the RX VLAN ID is 4004 in this example).
MAC 00-00-00-00-00-02 is authenticated with a target VLAN assigned. The ID of the target VLAN will be displayed (target
VLAN ID is 1234 in this example).
MAC 00-00-00-00-00-03 failed to pass authentication, and packets with SA 00-00-00-00-00-03 will be dropped no matter which
VLAN these packets are from.
To display the MAC-based access control authentication state:
DES-3200-28:4#show mac_based_access_control auth_state
Command: show mac_based_access_control auth_state
(P):Port based
Port MAC Address Auth State VID Priority Aging Time/Hold Time
----- ----------------- -------------- ---- -------- -----------
1 00-00-00-00-00-01 Authenticated 4004 3 Infinite
2 00-00-00-00-00-02 Authenticated 1234 - Infinite
3 00-00-00-00-00-03 Blocked 1 - 60
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh