D-Link xStack DES-3200 Series

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
47
5
config ethernet_oam ports (critical link event)
Used to co
nfigure Ethernet OAM critical link event for ports.
Purpose
config eth
ernet_oam ports [ <portlist> | all ] critical_link_event { dying_gasp | critical_event }
notify_state [ enable | disable ]
Syntax
The command used to configure the capability of Ethernet OAM critical link event. If the capability
for an event is disabled, the port will not send out the corresponding critical link event.
This table lists conditions that generate a critical link event:
Description
Condition Event Description
System Dying If a reboot command is input (CLI, WEB or MIB), the dying gasp
reboot gasp event will be sent out first, and then restart the device.
OAM disable Critical
event
If the OAM state changes from enable to disable for management, a
critical event shall be sent out.
Port Critical If the administrator shuts down the port, critical event will be sent out
shutdown event first before shutdown of the port.
<po
rtlist> - Specifies a range of ports to be configured. Use all to specify all ports.
Parameters
dying_gasp - An unrecoverable local failure condition has occurred
critical_event - An unspecified critical event has occurred.
notify_state - Specify to enable or disable the event notification. The default state is enable.
Only Administrator-level users
can issue this command.
Restrictions
Example usage :
To enable dying gasp notification event for port 1:
DES-3200-28F:4# config ethernet_oam ports 1 critical_link_event dying_gasp notify_state enable
Commands: config ethernet_oam ports 1 critical_link_event dying_gasp notify_state enable
Success
DES-3200-28F:4#