D-Link xStack DES-3200 Series - Page 493

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
48
8
config bpdu_protection trap/log
Used to co
nfigure trap and log settings for BPDU attack protection events.
Purpose
config b
pdu_protection [ trap | log ] [ none | attack_detected | attack_cleared | both ]
Syntax
Use this com
mand to configure the trap and log state for BPDU attack protection and specify the
type of event sent or logged.
Description
none – Spe
cifies that events will not be logged or trapped for both cases.
Parameters
trap – Specifies the trap state. The default state is both trap and log.
log – Specifies the log state. The default state is both trap and log.
attack_detected – Specifies that events will be logged or trapped when a BPDU attack is detected.
attack_cleared – Specifies that events will be logged or trapped when the BPDU attack is cleared.
both – Specifies that events will be logged or trapped for both cases.
The default setting for log is both and for trap is none.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the trap state for BPDU attack protection events to send traps for attacks detected and attacks cleared:
DES-3200-28F:4# config bpdu_protection trap both
Commands: config bpdu_protection trap both
Success.
DES-3200-28F:4#