D-Link xStack DES-3200 Series User Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
49
6
enable erps
Used to ena
ble the global ERPS function on the Switch.
Purpose
enabl
e erps
Syntax
This
command is used to enable the global ERPS function on the Switch. For each
ring with the ring state enabled when ERPS is enabled, the following integrity will be
checked:
Description
1. A R-APS VLAN is created.
2. The Ring port is a tagged member port of the R-APS VLAN.
3. The RPL port is specified if the RPL owner is enabled.
The default state is ERPS disabled.
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To globally enable ERPS:
DES-3200-28F:4# enable erps
Command: enable erps
Success.
DES-3200-28F:4#
disable erps
Used to disab
le ERPS function on the Switch. The default setting on the Switch is
ERPS disabled.
Purpose
disa
ble erps
Syntax
This will di
sable ERPS on the Switch. The default setting is ERPS disabled.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To globally disable ERPS:
DES-3200-28F:4# disable erps
Command: disable erps
Success.
DES-3200-28F:4#

D-Link xStack DES-3200 Series Specifications

General

Managed	Yes
Layer	Layer 2
MAC Address Table Size	8K
Quality of Service (QoS)	802.1p
Security Features	ACL, 802.1X, Port Security
Jumbo Frame Support	Up to 9KB
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Forwarding Rate	13.1 Mpps (48-port)