D-Link xStack DES-3200 Series - Page 502

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
49
7
create erps VLAN
Used to define an exis
ting VLAN as an R-APS VLAN on the Switch.
Purpose
cre
ate erps raps_vlan <vlanid>
Syntax
Use this com
mand to create a special R-APS VLAN that is used for transferring R-APS
control messages.
Description
Note: The R-APS VLAN must already have been created with the create vlan
command.
raps_vlan
<vlanid> - Designates the VLAN identified by the vlanid as the R-APS VLAN.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To create an R-APS VLAN:
DES-3200-28F:4# create erps raps_vlan 4094
Command: create erps raps_vlan 4094
Success.
DES-3200-28F:4#
delete erps VLAN
Used to remove an R-APS VLAN on the
Switch.
Purpose
delete erps
raps_vlan <vlanid>
Syntax
This
command will remove the R-APS VLAN as well all its configured parameters.
This command can only be issued when the ring is not active.
Description
raps_vlan
<vlanid> - Designates the VLAN identified by the vlanid as the R-APS VLAN
to be removed.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage
To remove an R-APS VLAN and its associated parameters:
DES-3200-28F:4# delete erps raps_vlan 4094
Command: delete erps raps_vlan 4094
Success.
DES-3200-28F:4#