xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
50
3
config erps log
Used to co
nfigure the status of the ERPS log function.
Purpose
config e
rps log [enable | disable]
Syntax
This
command is used to enable or disable logging of ERPS events.
Description
enabl
e | disable – Use to define the status of ERPS logging. Logging is disabled by
default.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable the ERPS logging function:
DES-3200-28F:4# config erps log enable
Command: config erps log enable
Success.
DES-3200-28F:4#
show erps
Used to displ
ay ERPS information.
Purpose
sho
w erps
Syntax
This
command is used to display ERPS configuration and operation information.
Description
The port state of the ring port may be as "Forwarding", "Blocking", "Signal Fail".
"Forwarding" indicates that traffic is able to be forwarded. "Blocking" indicates that traffic is
blocked by ERPS and a signal failure is not detected on the port. "Signal Fail" indicates
that a signal failure is detected on the port and traffic is blocked by ERPS.
The RPL owner administrative state could be configured to "Enabled" or "Disabled". But
the RPL owner operational state may be different from the RPL owner administrative
state, for example, the RPL owner conflict occurs. "Active" is used to indicate that the RPL
owner administrative state is enabled and the device is operated as the active RPL owner.
"Inactive" is used to indicate that the RPL owner administrative state is enabled, but the
device is operated as the inactive RPL owner.
Non
e.
Parameters
Non
e.
Restrictions
To Next Page
Loading...
Need help?
General
