D-Link xStack DES-3200 Series - Page 509

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
50
4
Example usage:
To display current ERPS information:
DES-3200-28F:4# show erps
Command: show erps
ERPS Information
---------------------------
ERPS Status : Enabled
R-APS VLAN : 8
West Port : 25 (Blocking)
East Port : 26 (Forwarding)
RPL Port : West Port
Owner : Enabled (Active)
Protection VLANs : 2
Ring MEL : 1
Holdoff Time : 0 ms
Guard Time : 500 ms
WTR Time : 5 minutes
Log : Disabled
Trap : Disabled
Current Ring State : Protection
DES-3200-28F:4#
config erps trap
Used to co
nfigure the trap status for ERPS.
Purpose
config e
rps trap [ enable | disable ]
Syntax
This
command is used to enable or disable the trap state for ERPS events.
Description
enabl
e | disable – Use to define the status of ERPS traps. ERPS traps are disabled
by default.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable ERPS traps:
DES-3200-28F:4# config erps trap enable
Command: config erps trap enable
Success.
DES-3200-28F:4#