D-Link xStack DES-3200 Series - Page 52

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
47
show snmp user
Used to displ
ay information about each SNMP username in the
SNMP group username table.
Purpose
s
how snmp user
Syntax
This
command is used to display information about each SNMP
username in the SNMP group username table.
Description
Non
e.
Parameters
Non
e.
Restrictions
Example usage:
To display the SNMP users currently configured on the Switch:
DES-3200-28:4#show snmp user
Command: show snmp user
Username Group Name SNMP Version Auth-Protocol PrivProtocol
--------------- --------------- ------------ ------------- ------------
initial initial V3 None None
Total Entries: 1
DES-3200-28:4#