D-Link xStack DES-3200 Series - Page 66

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
61
Exam
ple Usage:
To display the list of trust hosts:
DES-3200-28:4#show trusted_host
Command: show trusted_host
Management Stations
IP Address/Netmask
-----------------------
10.53.13.94/32
Total Entries: 1
DES-3200-28:4#
enable snmp
Used to ena
ble SNMP trap support.
Purpose
enabl
e snmp [authenticate_traps | linkchange_traps | traps]
Syntax
This
command is used to enable SNMP trap support on the Switch.
Description
authenti
cate_traps – This is to enable SNMP authentication trap support.
Parameters
linkchange_traps – This is to enable SNMP linkchange trap support.
traps – This is to enable SNMP trap support.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To enable SNMP trap support on the Switch:
DES-3200-28:4#enable snmp traps
Command: enable snmp traps
Success.
DES-3200-28:4#
To enable SNMP linkchange trap support on the Switch:
DES-3200-28:4#enable snmp linkchange_traps
Command: enable snmp linkchange_traps
Success.
DES-3200-28:4#
To enable SNMP authentication trap support:
DES-3200-28:4#enable snmp authenticate_traps
Command: enable snmp authenticate_traps
Success.
DES-3200-28:4#