D-Link xStack DES-3200 Series User Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
62
disable snmp
Used to disab
le SNMP trap support on the Switch.
Purpose
disa
ble snmp [authenticate_traps | linkchange_traps | traps]
Syntax
This
command is used to disable SNMP trap support on the Switch.
Description
authenti
cate_traps – This is to disable SNMP authentication trap
support.
Parameters
linkchange_traps – This is to disable SNMP linkchange trap support.
traps – This is to disable SNMP trap support.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To disable SNMP authentication trap support:
DES-3200-28:4#disable snmp authenticate_traps
Command: disable snmp authenticate_traps
Success.
DES-3200-28:4#
To disable SNMP linkchange trap support:
DES-3200-28:4#disable snmp linkchange_traps
Command: disable snmp linkchange_traps
Success.
DES-3200-28:4#
To prevent SNMP traps from being sent from the Switch:
DES-3200-28:4#disable snmp traps
Command: disable snmp traps
Success.
DES-3200-28:4#

D-Link xStack DES-3200 Series Specifications

General

Managed	Yes
Layer	Layer 2
MAC Address Table Size	8K
Quality of Service (QoS)	802.1p
Security Features	ACL, 802.1X, Port Security
Jumbo Frame Support	Up to 9KB
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Forwarding Rate	13.1 Mpps (48-port)