D-Link xStack DES-3200 Series - Page 68

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
63
config snmp linkchange_traps ports
Used to co
nfigure the sending of linkchange traps and per port
control for sending of change traps.
Purpose
config
snmp linkchange_traps ports [all | <portlist>] [enable | disable]
Syntax
This
command is used to configure the sending of linkchange traps
and per port control for the sending of change traps.
Description
all – To spe
cify all ports.
Parameters
<portlist> - To specify a port range.
enable – To enable the sending of a link change trap for this port.
disable - To disable the sending of a link change trap for this port.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure SNMP linkchange traps for ports 1 to 4:
DES-3200-28:4#config snmp linkchange_traps ports 1-4 enable
Command: config snmp linkchange_traps ports 1-4 enable
Success.
DES-3200-28:4#
show snmp traps
Used to sh
ow SNMP trap support on the Switch.
Purpose
sho
w snmp traps {linkchange_traps { ports <portlist>} }
Syntax
This
command is used to view the SNMP trap support status
currently configured on the Switch.
Description
linkcha
nge_traps – This displays the current SNMP linkchange trap
status.
Parameters
<portlist> – This specifies a list of ports to display SNMP trap
support.
Non
e.
Restrictions
Example usage:
To view the current SNMP trap support:
DES-3200-28:4#show snmp traps
Command: show snmp traps
SNMP Traps : Enabled
Authenticate Traps : Enabled
Linkchange Traps : Enabled
DES-3200-28:4#