D-Link xStack DES-3200 Series - Page 69

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
64
config snmp system_contact
Used to enter the name of a conta
ct person who is responsible for
the Switch.
Purpose
conf
ig snmp system_contact {<sw_contact>}
Syntax
This
command is used to enter the name and/or other information to
identify a contact person who is responsible for the Switch. A
maximum of 128 characters can be used.
Description
Parameters
<sw_contact>  A maximum of 128 characters is allowed. A NULL
string is accepted if there is no contact.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the Switch contact to “MIS Department II”:
DES-3200-28:4#config snmp system_contact MIS Department II
Command: config snmp system_contact MIS Department II
Success.
DES-3200-28:4#
config snmp system_location
Used to enter a descriptio
n of the location of the Switch.
Purpose
config snmp system
_location {<sw_location>}
Syntax
This
command is used to enter a description of the location of the
Switch. A maximum of 128 characters can be used.
Description
Parameters
<sw_location>  A maximum of 128 characters is allowed. A NULL
string is accepted if there is no location desired.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the Switch location for “HQ 5F”:
DES-3200-28:4#config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
DES-3200-28:4#