D-Link xStack DES-3200 Series - Page 70

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
65
config snmp system_name
Used to co
nfigure the name for the Switch.
Purpose
config snmp system
_name {<sw_name>}
Syntax
This
command is used to configure the name of the Switch.
Description
Parameters
<sw_name>  A maximum of 128 characters is allowed. A NULL
string is accepted if no name is desired.
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To configure the Switch name for “DES-3200-28 Switch”:
DES-3200-28:4#config snmp system_name DES-3200-28 Switch
Command: config snmp system_name DES-3200-28 Switch
Success.
DES-3200-28:4#
enable rmon
Used to ena
ble RMON on the Switch.
Purpose
enabl
e rmon
Syntax
This
command is used, in conjunction with the disable rmon
command below, to enable and disable remote monitoring (RMON)
on the Switch.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example Usage:
To enable RMON:
DES-3200-28:4#enable rmon
Command: enable rmon
Success.
DES-3200-28:4#