D-Link xStack DES-3200 Series

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
77
disable autoconfig
Use this to de
activate auto configuration from DHCP.
Purpose
disa
ble autoconfig
Syntax
This
command is used to instruct the Switch not to accept auto
configuration instruction from the DHCP server. This does not change
the IP settings of the Switch. The ipif settings will continue as DHCP
client until changed with the config ipif command.
Description
Non
e.
Parameters
Only Administrator-level users
can issue this command.
Restrictions
Example usage:
To stop the auto configuration function:
DES-3200-28:4#disable autoconfig
Command: disable autoconfig
Success.
DES-3200-28:4#
show autoconfig
Used to displ
ay the current autoconfig status of the Switch.
Purpose
s
how autoconfig
Syntax
This
command is used to list the current status of the auto
configuration function.
Description
Non
e.
Parameters
Non
e.
Restrictions
Example usage:
To display the autoconfig status:
DES-3200-28:4#show autoconfig
Command: show autoconfig
Autoconfig State: Disabled
Timeout : 50 sec
DES-3200-28:4#