D-Link xStack DES-3200 Series - Page 90

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
85
show utilization
Used to displ
ay real-time utilization statistics.
Purpose
show utilization [ cpu | dram | flash | ports {<portli
st>}]
Syntax
This
command is used to display the real-time utilization statistics for
the Switch.
Description
cpu – Entering this parameter will display the current CPU utilization
of the Switch.
Parameters
dram – Entering this parameter will display the current DRAM
utilization of the Switch.
flash – Entering this parameter will display the current Flash
utilization of the Switch.
ports – Entering this parameter will display the current port utilization
of the Switch.
<portlist> – Specifies a range of ports to be displayed.
Non
e.
Restrictions
Example usage:
To display the current CPU utilization:
DES-3200-28:4#show utilization cpu
Command: show utilization cpu
CPU Utilization :
------------------------------------------------------------------
Five Seconds - 3% One Minute - 2% Five Minutes - 5%
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
To display the current DRAM utilization:
DES-3200-28:4#show utilization dram
Command: show utilization dram
DRAM Utilization :
Total DRAM : 131,072 KB
Used DRAM : 65,604 KB
Utilization : 50%
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh