xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
90
create syslog host
Used to creat
e a new syslog host.
Purpose
create sy
slog host <index 1-4> {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress
[<ipaddr>] | state [enable | disable] }
Syntax
This
command is used to create a new syslog host.
Description
<index 1-4> Specifies that the command will be applied to an index of hosts. There are four
available indexes, numbered 1 through 4.
severity Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the Switch.
Parameters
Numerical Severity
Cod
e
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but significant condition
6 Informational: informational messages
7 Debug: debug-level messages
Numeri
cal Facility
Code
To Next Page
Loading...
