ENGLISH
68
11.13 DConnect Box Inputs and Outputs
Inputs I/O: I1, I2, I3, I4
Figure 9E – DConnect BOX I/0 6-pole terminal board
The DConnect Box is equipped with 4 non-optoinsulated voltage-controlled inputs.
They can be energised with positive DC voltages.
The Table describes the characteristics and the limits of the digital inputs:
Characteristics of the inputs (4 contacts)
Minimum switch-on
voltage [V]
2
Maximum switch-off
voltage [V]
0.5
Maximum admissible
voltage [V]
10
Current absorbed at 12V
[mA]
0.5
Accepted cable section
0.205-3.31 [mm²]
24-12 [AWG]
An example of connection of the input terminals is:
Applying a 0-10V voltage between input I1 and GND.
If the voltage is higher than 2V the input I1 will be active, if less than 0.5V it will be
deactivated.
To Next Page
Loading...