DACE RT25/50 - Ultima Technical Specifications; Gate System Components and Site Preparation; Areas Where Injury or Entrapment Can Occur

5
 DACE cannot be held responsible for a gate bumping either of the ends stops if it runs on a slope.
 Do not operate the gate unless within direct sight of the gate.
 A gate is a heavy piece of equipment and injury, even death, may occur due to incorrect installaon or opera-
on of the equipment. There are a number of areas that may cause entrapment which could lead to injury.
ULTIMA TECHNICAL SPECIFICATIONS
……..connued
AREAS WHERE INJURY OR ENTRAPMENT CAN OCCUR
1. Gate Wheels (Pets at risk when lying at the gate)
2. Between the gate & the end stop
3. The gate, during the closing cycle
4. Between the gate & the catch bracket
5. Pinion Gear
6. Between the gate operator & the gate
7. Gate Rollers/An-li device
8. The gate, during opening cycle
1.
2.
3.
4.
7.
5. & 6.
8.
2.