1-20 HOW TO HANDLE THE VEHICLE
• Low air pressure warning signal for park-
ing brake circuit
When air pressure in parking tank falls to the
"cut-in" pressure (around 5.3bar), the low air
pressure warning signal comes on. After
that, if it continues to fall to 4.2bar, the low
air pressure warning lamp blinks. At this
moment, for your safety, do not drive until
the air reservoir holds enough air to allow
the brake to be used.
MTS0525
• Seat belt warning lamp
The seat belt warning lamp comes on when
the ignition switch is placed in the "ON"
position unless the driver's seat belt is se-
curely fastened.
MTA0561
• Parking brake indicator lamp
The parking brake indicator lamp comes on
when the parking brake lever is pulled with
the starter switch "ON".
Before moving your vehicle, be sure to check
P
that the parking brake indicator lamp is off.
MTS0571
• Engine oil pressure warning lamp
This warning lamp comes on when oil level
is improperly low or lubricating system is out
of order. At this time, immediately stop the
vehicle and check the engine oil level and
lubricating system.
MTA0581
https://www.truck-manuals.net/
To Next Page
Loading...
