Daewoo Novus M2SEF - Injection Nozzle; Fuel Tank; Change of Coolants

3-82 INSPECTION AND MAINTENANCE
Engine model
DE12TI
DE12TIS
DV15T
DV15TI
DV15TIS
DDC
Injection pressure
220/160 kg/cm
2
220 kg/cm
2
210 kg/cm
2
204 kg/cm
2
250 kg/cm
2
352 kg/cm
2
11) Injection nozzle
At end of first 5,000km and thereafter at every
10,000km (DDC engine:192,000km) for new ve-
hicle, check injection pressure and spray condi-
tion of injection nozzle. As nozzle test is required
to make such inspection, contact your nearest
Daewoo dealer for nozzle test.
12) Fuel tank
Remove drain plug from fuel tank, and take out
the strainer to clean it at every 8,000km.
Clean the inside of the fuel tank and drain water
and sediments at every 24,000km.
MTC0260
MTB0470
13) Change of coolants
Drain the coolant by opening the radiator drain
cock, engine water drain cock and oil cooler cover
plug. After completely draining off, close the drain
cock and fill with water. Run the engine for about
10 minutes and then recheck the coolant level. In
the case that antifreeze is added to coolant, it is
advisable to clean the inside of the radiator and
engine water jacket 2 times a year(in spring and
autumn).
Specifications: EDS M - 8207
Antifreeze freezing curve
Engine model
DE12TI
DE12TIS
Coolant volume
39.6L
39L
0
-10
-20
-30
-40
-50
-60
0 5 10 15 20 25 30 35 40 45 50 55 60
DV15T
DV15TI
DV15TIS
DDC
38.6L
39.6L
40L 45L
Mixing ratio(%)
MTC0280
*
*
Antifreeze and water mixing ratio: 50/50 for all
around the year
Operation and care in cold weather.
Temperature(

C)
https://www.truck-manuals.net/