3-86 INSPECTION AND MAINTENANCE
17) Air Bleeding of clutch hydraulic circuits
1) Fill the clutch fluid reservoir to the specified level
with clutch fluid and keep it filled during bleed-
MAX ing operation.
MIN
MTC0343
Air bleeding
screw
MTC0351
2) Remove bleeder rubber cap and connect a vi-
nyl pipe to the bleeder and hold free end of the
pipe in a transparent container filled with clutch
fluid.
3) Pump the clutch pedal several times and hold
the pedal depressed.
4) With the pedal depressed, loosen the bleeder
half a turn to discharge air-mixed clutch fluid and
tighten it immediately.
5) Repeat the above steps of operation until air
bubbles disappear completely from the fluid be-
ing forced out.
MAX
MIN
MTC0343
6) After the completion of bleeding operation,
check for pedal free play and clutch operation,
then check that the level of clutch fluid in the
reservoir is normal.
Caution
Don't need additional adjustment of pedal free play
as fixed in the factory. But before the air bleeding,
check the pedal free play because master cylinder
has no clearance, that is, booster is continusously
pushing the clutch master cylinder.
https://www.truck-manuals.net/
To Next Page
Loading...
