1-6 HOW TO HANDLE THE VEHICLE
3) How to lower the cab
(1) Position the direction change lever in "D" posi-
descending tion.
position
MTA1231
(2) If you insert cap tilt lever into pump socket and
move it up and down, cab will descend.
(3) Make sure that lock lever is locked into hook.
(Except for the vehicle that the hydraulic cab
lock option system is applied)
MTA1250
Inside the cab
4) How to lift the cab (Hydraulic cab latch :
option)
(1) Pull forward lock lever located at the lower right-
hand side of the rear of the cab while lifting the
hook, and then the lock will be released.
Hook
Lock
lever
MTA1240
tilting
position
MTS0190
MTA1210
Push cab tilt enable switch to "ON" position lo-
cated in instrument panel inside the cab in case
of the hydraulic cab lock option system is ap-
plied in the vehicle.
(2) Turn the direction change lever installed onto
the pump located at the rear lower right-hand
side of the cab to set it to "U" position.
(3) Press the switch as shown, and then the pump
works and the cab starts to ascend.
https://www.truck-manuals.net/
To Next Page
Loading...
