1-33 HOW TO HANDLE THE VEHICLE
(7) Power take-off switch(for dump, special
purpose truck)
This switch is used to operate the power take-
off device. When the switch is pressed to "ON",
the P.T.O. device starts working, P.T.O. indica-
tor lamp on the instrument panel is turned on,
and warning buzzer sounds all the while P.T.O.
works. When the deck is raised, warning buzzer
sounds continuously even though the P.T.O.
switch is turned to "OFF".
MTA0721
Caution
Stop the vehicle and depress the clutch pedal all
the way to the floor before operating this switch.
(8) RES/INC switch(DDC engine)
Pressing this switch while CRUISE/PTO switch
RES/INC
SET/DEC
MTA0716
is activated results in increase of vehicle speed,
Vehicle speed will be maintained constantly
when de-pressing the switch. Pressing brake or
clutch pedal will disengage cruise control func-
tion. Repress the switch will maintain the ve-
hicle speed at which the pedal pressed.
(9) SET/DEC switch (DDC engine)
Pressing this switch while CRUISE/PTO switch
is activated results in constant vehicle speed,
Vehicle speed will be decreased if this switch is
pressed when CRUISE CONTROL is activated.
De-press the switch will maintain the vehicle
speed again.
CRUISE
PTO
MTA0717
(10) CRUISE/PTO switch(DDC engine)
CRUISE CONTROL function controls fuel
flows and set vehicle speed at which the op-
erator requires. Pressing CRUISE CONTROL
activates the function.
MDD0734
https://www.truck-manuals.net/
To Next Page
Loading...
