Dahua XVR5116HS User Manual

553
Parameter
Function
Period
Set tripwire valid period. System generates an alarm during the specified
period. For detailed setups, please refer to chapter 5.10.3.1.1 motion detect.
Step 6 Click Save to complete setup.
5.10.3.2.3 Abandoned Object Detect
It is to detect there is any abandoned object in the surveillance area for the specified time.
Note:
 The abandoned object detection function is valid once your network camera or your
DVR supports this function.
 If you want to use the IVS function of the network camera, please make sure your
connected network camera supports this function.
Step 1 From main menu->Setup->Event->IVS, click to add the rule. Select rule
type as abandoned object detection.
Note
Double click to change a rule name.
Step 2 Check the box to enable abandoned object detection function. See Figure 5- 82.
Figure 5- 82
Step 3 Click Draw rule to draw the rule. See Figure 5- 83. Left click mouse to draw a line,
until you draw a rectangle, you can right click mouse.

Dahua XVR5116HS Specifications

General

USB Interface	2 USB 2.0 ports
Power Supply	DC 12V/2A
Video Output	1 HDMI, 1 VGA
Operating System	Embedded Linux
Video Compression	H.264+/H.264
Analog Camera Input	16 channel, BNC
IP Camera Input	Up to 16 channels
Audio In/Out	1/1, RCA
Display Resolution	1920 × 1080, 1280 × 1024, 1280 × 720
Network Interface	1 RJ-45 Port (10/100 Mbps)
HDD	1 SATA port, up to 6 TB
Dimensions	260 mm × 238 mm × 48 mm (W × D × H)
Smart Functions	SMD Plus
VGA Output	1920 × 1080, 1280 × 1024, 1280 × 720
Operating Temperature	-10°C to +55°C
Operating Humidity	10%–90% (RH), non-condensing