Daikin ACS320 - Actual Signals and Parameters

aCTual sIgnals and parameTers
This section describes the actual signals and parameters that a Daikin user needs to understand and gives the
eldbus equivalent values for each signal/parameter. It also contains a table of the default values for the different
macros. See page 108 for recommended Daikin values.
NOTE: When the control panel is in the short parameter
view, ie when parameter 1611 PARAMETER VIEW is
set to 2 (SHORT VIEW), the control panel only shows
a subset of all signals and parameters. The list of
these signals and parameters starts on page 31.
To be able to view all actual signals and parameters, set
parameter 1611 PARAMETER VIEW to 3 (LONG VIEW). The
descriptions of parameters start on page 31.
Terms and Abbreviations
Term Denition
Actual signal Signal measured or calculated by the drive. Can be monitored by the user. No user setting possible.
Groups 01…04 contain actual signals.
Def Parameter default value
Parameter A user-adjustable operation instruction of the drive. Groups 10…99 contain parameters.
NOTE: Note: Parameter selections are shown on the Basic Control Panel as integer values. Eg
parameter 1001 EXT1 COMMANDS selection COMM is shown as value 10 (which is equal to
the eldbus equivalent FbEq).
FbEq Fieldbus equivalent: The scaling between the value and the integer used in serial communication.
OM 1190-1 • MD4 VFD 30 www.DaikinApplied.com
aCTual sIgnals and parameTers