13
3. Select OPERATION CODE to display the opera-
tion code setting screen.
4. Using the ALL button (5) or one of the individual
group selection buttons (6) (1 - 16), select the air
conditioner (group) in which an operation code is
to be set.
5. Press the or button (4) to set an operation
code.
Press the button to increment the operation
code. Press the button to decrement the opera-
tion code.
6. Press the SET/CANCEL button (3) once to com-
plete the operation code setting procedure.
The operation code indication blinks for 3 seconds
and changes to constant On. Then, the display
returns to the ALL screen if the setting was made
in the ALL screen, or to the INDIVIDUALLY screen
if the setting was made in the INDIVIDUALLY
screen.
* The operation code entered last takes prece-
dence. Therefore, if the setting is made in the
ALL screen after the setting is entered in the
INDIVIDUALLY screen, the setting made in the
ALL screen will be applied.
NOTE
1. Operate buttons while the backlights are lit.
2. In steps 2 through 5, if no button is operated for
1 minute, the display returns to the ALL screen
when the setting was made in the ALL screen, or to
the INDIVIDUALLY screen if the setting was made
in the INDIVIDUALLY screen.
In the above-mentioned case, the setting being
entered will not be applied.
[Screen Display]
A. While the ALL or INDIVIDUALLY screen is dis-
played, press the FUNCTION button (1) once.
B. The Function Menu appears. The Function Menu
changes as follows when the or button (2) is
pressed.
If no button is pressed for 2 seconds while the dis-
play shows screen B to screen E on page 13, a
guidance message, ā BUTTONS: CHANGE
FUNCTION, BUTTONS: CHANGE OPERA-
TION CODE, SET/CANCEL BUTTON: SET,ā
appears in the operation mode display section (dot
matrix).
C. Select OPERATION CODE to display the opera-
tion code setting screen.
D. Using the ALL button (5) or one of the individual
group selection buttons (6) (1 - 16), select the air
conditioner (group) in which an operation code is
to be set.
E. Press the or button (4) to set an operation
code.
Press the button to increment the operation
code. Press the button to decrement the opera-
tion code.
A
B
OPERATION
CODE
RESET
FILTER SIGN
OUTDOOR
TEMP
DISPLAY
DAYLIGHT
SAVING
SET DAYLIGHT
SAVING TIME
CONTRAST
KEY
LOCK
C
D
E
01_EN_3P124623-10N.fm Page 13 Monday, January 28, 2008 4:58 PM
To Next Page
Loading...
