Daikin DCS303A51 - Schedule Setting: Clear Timer

38
I. If no button is operated for 1 minute or the SCHED-
ULE button (1) is pressed once, the display returns
to the ALL screen when the setting was made in
the ALL screen, or to the INDIVIDUALLY screen
when the setting was made in the INDIVIDUALLY
screen.
If the setting copied by the above operation is for
an operation to be activated after the current time,
it is displayed on the Schedule screen.
SCHEDULE SETTING: CLEAR
TIMER
 Clearing ON/OFF setting to “--:--”
[Operating Procedure]
1. While the ALL or INDIVIDUALLY screen is dis-
played, press the SCHEDULE button (1) once.
2. The Schedule setting screen appears.
3. Press the ALL button (4) or one of the individual
group selection buttons (5) (1 - 16) to select an air
conditioner (group) for which the timer is to be
cleared.
4. Press the or button (2) to select the day of the
week for the clearing of timer setting.
5. Using the or button (3), select the Timer No.
to be cleared.
6. Press the SET/CANCEL button (6) once to apply
the settings.
7. The Time setting screen appears. Using the or
button (3), select “CLEAR TIMER”.
8. Press the SET/CANCEL button (6) once to com-
plete the setting procedure.
9.
If no button is operated for 1 minute or the SCHED-
ULE button (1) is pressed, the display returns to the
ALL screen when the setting was made in the ALL
screen, or to the INDIVIDUALLY screen when the
setting was made in the INDIVIDUALLY screen.
NOTE
1. Operate buttons while the backlights are lit.
2. In each of steps 2 through 7, if no button is operated
for 1 minute, the display returns to the ALL screen
when the setting was made in the ALL screen, or to
the INDIVIDUALLY screen when the setting was
made in the INDIVIDUALLY screen.
In the above-mentioned case, the setting being
entered will not be applied.
[Screen Display]
A. While the ALL or INDIVIDUALLY screen is dis-
played, press the SCHEDULE button (1) once.
B. The Schedule setting screen appears.
If no button is operated for 2 seconds while the dis-
play shows screen B to screen E on page 38, a
guidance message, “ BUTTONS: SELECT
TIMER No., BUTTONS: SELECT DAY OF
THE WEEK, SET/CANCEL BUTTON: SET,”
appears and scrolls in the operation mode display
section (dot matrix).
C. Press the ALL button (4) or one of the individual
group selection buttons (5) (1 - 16) to select an air
conditioner (group) for which the schedule setting
is to be cleared.
(1)
(4)
(6)
(5)
(3)
(2)
TIMER 1 ON
TIMER 1 OFF
TIMER 4 ONTIMER 4 OFF
·····
A
B
C
01_EN_3P124623-10N.fm Page 38 Monday, January 28, 2008 4:58 PM