Daikin DCS303A51 - Contrast Setting

To Next Page

To Previous Page

U. If no button is operated for 1 minute or if the FUNC-

TION button (1) is pressed once, the display

returns to the INDIVIDUALLY screen.

CONTRAST SETTING

 Adjusting the contrast of the LCD

[Operating Procedure]

1. While the ALL or INDIVIDUALLY screen is dis-

played, press the FUNCTION button (1) once.

2. The Function Menu appears.

The Function Menu changes as follows when the

or button (2) is pressed.

3. On the Contrast setting screen, adjust the contrast

level by using the or button (3).

* The contrast level is set to “3” by default.

4. If no button is operated for 1 minute or the FUNC-

TION button (1) is pressed, the display returns to

the ALL screen when the setting was made in the

ALL screen, or to the INDIVIDUALLY screen when

the setting was made in the INDIVIDUALLY

screen.

NOTE

1. In each of steps 2 through 4, if no button is operated

for 1 minute, the display returns to the ALL screen

when the adjustment was made in the ALL screen,

or to the INDIVIDUALLY screen when the adjust-

ment was made in the INDIVIDUALLY screen.

[Screen Display]

A. To adjust the contrast, press the FUNCTION

button (1) once while the ALL or INDIVIDUALLY

screen is displayed.

B. The Function Menu appears.

If no button is pressed for 2 seconds, a guidance

message, “ BUTTONS: CHANGE FUNC-

TION, BUTTONS: CHANGE OPERATION

CODE, SET/CANCEL BUTTON: SET” appears in

the operation mode display section (dot matrix).

C. Each time the or button (2) is pressed, the

Function Menu changes in the following sequence:

Display the Contrast setting screen.

(1)

(2)

(3)

OPERATION

CODE

RESET

FILTER SIGN

OUTDOOR

TEMP

DISPLAY

DAYLIGHT

SAVING

SET DAYLIGHT

SAVING TIME

CONTRAST

KEY

LOCK